Ara
Toplam kayıt 11, listelenen: 1-10
Acoustic analysis of a liquefied petroleum gas-fired pulse combustor
(2008)
Experimental investigation of acoustic characteristics of a Helmholtz type liquefied petroleum gas-fired pulse combustor is presented. In the experiments, the length of the tail pipe was changed from 1.9 m to 1.3 m by 10 ...
Residual stress analysis and expansion of plastic zone in simple supported woven Ni-Cr reinforced thermoplastic matrix composite laminated plates
(2006)
In this study, a residual stress analysis is carried out on symmetric and antisymmetric cross-ply and angleply thermoplastic simple supported laminated plates for transverse loading. Low density polyethylene thermoplastic ...
Residual stress analysis snd expansion of plastic zone in simple supported and clamped supported woven Ni-Cr reinforced thermoplastic matrix composite laminated plates
(2007)
In this study, a residual stress analysis is carried out on symmetric cross-ply and angle-ply thermoplastic simple supported and clamped supported laminated plates for transverse loading. Low density polyethylene thermoplastic ...
An elastic-plastic stress analysis of woven Ni-Cr reinforced thermoplastic composite cantilever beam
(2007)
In the present study an analytical elastic-plastic stress analysis is carried out for a low-density homogeneous polyethylene thermoplastic cantilever beam reinforced by Ni-Cr steel fibers. The beam is loaded by a constant ...
Residual stress analysis of aluminum metal matrix composite laminated plates with a square hole
(2009)
Metal matrix composites provide new materials with superior properties. They give high strength and stiffness. In this study, a stainless steel reinforced aluminum metal matrix laminated simple supported plate with a square ...
An experimental investigation of heat transfer enhancement in a rectangular duct with plate fins
(2009)
In this study, using an ideal heat exchanger model, a detailed evaluation of performance parameters in the turbulent regime for the enhancement of heat transfer by using winglet-type vortex generators is carried out. The ...
Experimental investigation of a cross-flow heat exchanger with wing-type vortex generators
(2008)
In this study, heat and fluid flow in a plate-fin heat exchanger with wing-type convergent-divergent longitudinal vortex generators (CDLVGs) were studied experimentally. A cross-flow plate-type heat exchanger was designed ...
Exergy transfer in a porous rectangular channel
(Elsevier Ltd, 2009)
Present paper is performed to investigate the heat and exergy transfer characteristics of forced convection flow through a horizontal rectangular channel where open-cell metal foams of different pore densities such as 10, ...
Sizing problem for a cross flow heat exchanger with wing-type vortex generator
(2009)
In the present study, sizing of a single pass cross flow heat exchanger with unmixed fluid streams has been investigated. The heat exchanger is a cross flow heat exchanger. It has overall dimensions of 20 × 20 × 20 cm. Two ...
An elastic-plastic stress analysis steel-reinforced thermoplastic composite cantilever beam
(2008)
In the present study an analytical elastic-plastic stress analysis is carried out for a low-density homogeneous polyethylene thermoplastic cantilever beam reinforced by steel fibers. The beam is loaded by a constant single ...