Ara
Toplam kayıt 7, listelenen: 1-7
Determination of noise level of a gas-fired pulse combustor
(2007)
Experimental determination of noise level of a Helmholtz type gas-fired pulse combustor is presented. During the tests, the tail pipe length was varied from 1.9 m to 1.3 m by 10 cm intervals. Noise level measurements were ...
Comparison of the curing kinetic behavior for two epoxy resin systems containing EPIKOTE 828-EPIKURE 3090 and DURATEK KLM 606a-DURATEK KLM 606b
(2007)
The aim of the study is to determine the optimum cure temperatures and kinetics for two different epoxy resin systems without using solvent. Two resin systems consist of EPIKOTE 828® epoxy resin-EPIKURE® 3090 polyamidoamine ...
Residual stress analysis snd expansion of plastic zone in simple supported and clamped supported woven Ni-Cr reinforced thermoplastic matrix composite laminated plates
(2007)
In this study, a residual stress analysis is carried out on symmetric cross-ply and angle-ply thermoplastic simple supported and clamped supported laminated plates for transverse loading. Low density polyethylene thermoplastic ...
An elastic-plastic stress analysis of woven Ni-Cr reinforced thermoplastic composite cantilever beam
(2007)
In the present study an analytical elastic-plastic stress analysis is carried out for a low-density homogeneous polyethylene thermoplastic cantilever beam reinforced by Ni-Cr steel fibers. The beam is loaded by a constant ...
Ascetic and devotional elements in the Mu'tazilite tradition: The Sufi Mu'tazilites
(Blackwell Publishing Ltd, 2007)
The Mutazilite thinkers are most often defined as rationalist, individualist, liberal and eccentric figures. To the above qualities, one should add ascetic and devotional aspects. Among the Mutazilite famous ascetics are ...
The effect of austenitizing time on martensite morphologies and magnetic properties of martensite in Fe-24.5%Ni-4.5%Si alloy
(2007)
The effect of austenitizing time on the formation of martensite in Fe-24.5%Ni-4.5%Si alloy has been studied by means of transmission electronmicroscope (TEM), scanning electronmicroscope (SEM) and Mössbauer spectroscopy ...
Some aspects of thermally induced martensite in Fe-30% Ni-5% Cu alloy
(2007)
Kinetical, morphological, crystallographical and several thermal properties of thermally induced martensite in the austenite phase ofFe–30% Ni–5% Cu alloy were investigated. Scanning electron microscope (SEM), transmission ...